Service
Resin Driveway Repairs
Repairs to existing resin surfaces: cracking, loose or shedding stone, oil staining, and surfaces that have failed because of what lies underneath.
What tends to go wrong, and why
Most resin surface failures are base failures wearing a resin coat. Cracking that follows a straight line, areas that sink underfoot, or a surface that has broken up in the wheel tracks are all symptoms of a sub-base that was never adequate, and resurfacing over the top of them buys perhaps two years before the same fault reappears in the same place.
Failures in the surface itself are different and more repairable. Stone shedding loose usually means the resin-to-aggregate ratio was wrong, the mix was under-agitated, or the pour was rained on before it cured. Ambering or yellowing points to a cheaper epoxy binder rather than a UV-stable polyurethane. Surface crazing can follow a pour laid in conditions that were too cold or too hot.
The first job on any repair is establishing which of the two you have, because the answers are completely different. A patch repair on a failed base is money spent twice.
What a repair involves
Localised damage is cut out to a clean edge, the base beneath checked and made good, and a fresh batch of matching aggregate and resin trowelled in to the same depth. The join is the honest limitation: a fresh pour against several years of weathering rarely matches exactly, and the repair will be visible for a period before it settles down.
Oil staining is a different problem and often treatable without cutting anything out, depending on how long it has been there and how far it has penetrated. Fresh spills lift far more readily than old ones, which is the argument for dealing with them promptly.
Where we cover
Common questions
My resin drive is shedding loose stone. Can it be fixed?
Usually, and it is worth diagnosing rather than just topping up. Loose stone generally means the original mix was resin-poor, was not agitated long enough, or was caught by rain before curing. If the surface underneath is otherwise sound, the affected area can be cut out and re-laid. If stone is coming loose across the whole drive, that points to a systemic problem with the original installation, and re-laying the whole surface is often more sensible than repeatedly patching it.
Can you resurface over a cracked resin driveway?
You can, but you often should not, and this is where an honest answer saves money. If the cracking comes from movement or failure in the base beneath, a new surface laid over it will crack again in the same place within a couple of years, and you will have paid twice. Cracking confined to the resin layer over a sound base is a different case and can genuinely be resurfaced. Establishing which one you have is the first step, and any installer who skips it is not doing the job properly.
Will a repair match the rest of the driveway?
It will be close rather than invisible. Aggregate varies between quarry batches, and an existing surface will have weathered and picked up traffic film that a fresh pour has not. The repair usually stands out for a while and then settles as it weathers in. Knowing the exact original blend improves the match considerably, so it is worth asking for that detail in writing whenever a new surface is laid.
Enquire about repairs
Tell us what is there now and we will explain what it is likely to cost and whether a base like yours can usually be overlaid, then put you in touch with an installer where one covers your area. No charge for that, and no obligation.